42 FX Loop Send
43 FX Loop Return
44 FX Loop Balance
NOTE:
45, 46 Poweramp Output, 4 Ohms Parallel
47, 48 Poweramp Output, 8 Ohms Parallel
49 Poweramp Output, 16 Ohms
IMPORTANT NOTE, please read and heed:
Connect to a signal processor's input/return jack using the shortest
possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled
remotely (: on/off) via a footswitch connected to jack 38 (for details refer to chapter
38) or via the ENGL Custom Footswitch Z-9 (refer to chapter 37 for details). In the
signal path, the located post preamp and pre the two power amp Master
knobs.
Connect the input to a signal processor's output/send jack using the shortest
possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled
remotely (: on/off) via a footswitch connected to jack 38 (for details refer to chapter
38) or via the ENGL Custom Footswitch Z-9 (refer to chapter 37 for details). In the
signal path, located post preamp and pre the two power amp Master
knobs.
FX mix control for the . When the knob is set to , the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to when this loop is not in use! S
4 ohms speaker output jacks, internal connected parallel. For diverse cabinet options
!
8 ohms speaker output jacks, internal connected parallel. For diverse cabinet options
!
16 ohms speaker output jack. For diverse cabinet options
!
Never operate the power amp without a
sufficient load, otherwise you may damage or destroy it! Always check the connected
cabinets' impedance to confirm it matches the amp's output impedance! For example,
if you are connecting a cabinet to one of the two 8-ohms output, make sure the
speaker system is indeed rated for 8 ohms. You'll find the various speaker and cabinet
options listed in the nest section. I cannot stress enough the importance of proper
impedance matching when connecting one or more cabinets to your amp. Impedance
mismatching can damage the power amp!
FX Loop Dry
Dry
abinet options
abinet options
abinet
options
the FX Loop output
FX Loop is
FX Loop
FX Loop is
ettings between the 9 and 3
o'clock position reduce the signal level.
see the chapter on page 18
see the chapter on page 18
see the chapter
on page 18
C
C
C
17
(12 páginas)
(37 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais