You can switch between and using a Z-9 Custom Footswitch (S.A.C.
F1-1, page26) connected to the S.A.C. Port (37) or a footswitch connected to jack (39).
If you want to experience real remote control convenience, try an ENGL Z-9 foot
controller. You can dial in different levels for and , assign these
settings to any channel and access them directly via the four channel switches on the
ENGL Z-9 foot controller. This gives you a range of alternatives that you can apply to
different playing styles and musical genres to great dramatic effect. What's more, you
can use Clean & Crunch mode for rhythm or cleaner lead lines and Channel 3's or
Channel 4's overdriven preamp stage for power chords and soloing, and go from soft
to loud at the touch of a button. Beyond that, you can also broaden the volume and
tonal ranges by working your guitars' volume knob. If your arsenal includes MIDI gear -
for instance, the Z-11 ENGL MIDI Switcher in combination with the Z-9 Custom
Footswitch - you may use the amp's Master A/B circuit to swiftly and conveniently set
the power amp's volume to two different levels, and then access these volume presets
in combination with preamp voicing features such as . The mind
boggles…
Power amp standby switch: Use this switch to silence (0 position) the amp when you
take longer break. The amp's tubes stay nice and toasty, and the amp is ready to roll
immediately when you ramp it back up to full power.
I suggest you get into the habit of using standby during short breaks. In this mode,
current is not piped through the power tubes, so they don't get as hot (due to the lack
of anode dissipation) and are spared considerable wear. The amp is ready to run when
you flip the Standby switch because the tubes are already warm and don't require time
to heat up. For breaks of 30 minutes and longer, I recommend that you switch the amp
off in order to conserve energy.
Mains power on/off.
ensure that the Stand By switch (33) is set to (0 position) before
you switch the amp on. Let the tubes heat up for about 30 seconds before you activate
the power amp. This procedure spares the tubes.
Master A Master B
Master A Master B
Middle-boosted
Stand By
A tip from the designer:
33 Stand By
A tip from the designer:
34 Power
CAUTION: After an extended period of operation and higher ambient temperatures
the amps's chassis can become very hot, therefore avoid touching the rear panel
surface !
For more details see the chapter 37 and 39 on page 14 and 15!
Please note:
13
(12 páginas)
(37 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais