Engl E765 Manual do Operador descarregar pdf (Página 15)

the fact that it suppresses extraneous noise means you can't hear those telltale signs

that feedback is swelling and consequently can't take measures to suppress it. For this

reason, make an extra effort to be careful when the is activated: Before

you approach the amp and speaker cabinet with your guitar in hand, turn the guitar's

volume knob to the far left position (to 0 so that no signal is audible) to prevent the

pickups and speakers from interacting!

Connect to a signal processor's input/return jack using the shortest

possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled

remotely (: on/off) via a footswitch connected to jack 22 (for details refer to chapter

22) or via the ENGL Custom Footswitch Z-9 (refer to chapter 21 for details). In the

signal path, the located post preamp and pre the two power amp Master

knobs.

NOTE: The FX Loop Send output is removed from the preamp signal path when the FX

Loop is deactivated.

Connect the input to a signal processor's output/send jack using the shortest

possible shielded cord equipped with 1/4" plugs. The FX Loop can be controlled

remotely (: on/off) via a footswitch connected to jack 22 (for details refer to chapter

22) or via the ENGL Custom Footswitch Z-9 (refer to chapter 21 for details). In the

signal path, located post preamp and pre the two power amp Master

knobs.

FX mix control for the . When the knob is set to , the amp signal is routed

through with no processed signal (0% wet balance) added to the mix. Twist the knob

clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,

depending on knob position). When the knob arrives at the Effect position, only the

wet signal (that is, the processed signal generated by the connected effect device) is

patched to the power amp (serial, 100% wet).

Set this knob to when this loop is not in use! S

A fuse in the rear chamber of this fuse drawer protects the V5 power tube. It is

designed to blow in the event of an electrical problem with tube V5. The Power Tube

Fuse LED (28) lights up to indicate that one or several of the four fuses has blown.

There is a replacement fuse in the front chamber of the fuse drawer.

Always make sure replacement fuses are of the same type and

have the same ratings as the original fuse! See section 28 for some more key facts

about tube defects.

Noise Gate

FX Loop Dry

Dry

30 FX Loop Send

31 FX Loop Return

32 FX Loop Balance

NOTE:

33 Power Tube V5 Fuse

CAUTION: Switching off the amp and pull the mains plug before opening the fuse

drawer!

Need-to-know info:

the FX Loop output

FX Loop is

FX Loop

FX Loop is

NOTE: The effect signal at the FX Loop Return input is removed from the signal path

when the FX Loop is deactivated.

ettings between the 9 and 3

o'clock position reduce the signal level.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Comentários a estes Manuais

Sem comentários

Engl E765 Manual do Operador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Amplificadores para Instrumentos Musicais Engl E765